Validity of Asphalt Binder Film Thickness Concept in Hot-Mix Asphalt
Abstract
Despite the possible benefits of implementing asphalt binder film thickness into current specifications to address durability problems, most of the related research has been theoretical and only a few attempts have been made to measure this property experimentally. The objective of this study was to investigate the concept of asphalt binder film thickness experimentally on the basis of measurements obtained by image analysis techniques, reflective light microscopy, and scanning electron microscopy. The results of the experimental program were used to gain insight into the concept of asphalt binder film thickness and its validity. Experimental results indicated that asphalt binder films coating large aggregates do not actually exist in hot-mix asphalt. Instead, what are referred to as asphalt binder films surrounding large aggregates are actually asphalt mastic films. These films are highly irregular in shape and have a thickness greater than 100 μm in the mixture considered in this study. The asphalt binder films in the mastic were observed at a thickness of 2 μm in the mixtures considered. However, these entities do not represent asphalt binder coatings around aggregates; they are only part of a blend with fine aggregates and mineral fillers. Microscopic analysis showed that air voids usually appear near the boundary between large aggregates and asphalt mastic.
Get full access to this article
View all access and purchase options for this article.
References
1. Kandhal P. S., and Chakraborty S. Effect of Asphalt Binder Film Thickness on Short and Long Term Aging of Asphalt Paving Mixtures. NCAT Report 96-01. National Center for Asphalt Technology, Auburn, Ala., 1996.
2. Hinrichsen J. A., and Heggen J. Minimum Voids in Mineral Aggregate in Hot-Mix Asphalt Based on Gradation and Volumetric Properties. In Transportation Research Record 1545, TRB, National Research Council, Washington, D.C., 1996, pp. 75–79.
3. Kandhal P. S., Foo K. Y., and Mallick R. B. A Critical Review of VMA Requirements in Superpave. NCAT Report 98-01. National Center for Asphalt Technology, Auburn, Ala., 1998.
4. Roberts F. L., Kandhal P. S., Brown E. R., Lee D., and Kennedy T. W. Hot Mix Asphalt Materials, Mixture Design, and Construction, 2nd ed. Napa Education Foundation, Lanham, Md., 1996.
5. Radovskiy B. Analytical Formulas for Film Thickness in Compacted Asphalt Mixture. In Transportation Research Record: Journal of the Transportation Research Board, No. 1829, Transportation Research Board of the National Academies, Washington, D.C., 2003, pp. 26–32.
6. Eriksen K., and Wegan V. Optical Methods for the Evaluation of Asphalt Concrete and Polymer-Modified Bituminous Binders. Note 244. Danish Road Institute, Roskilde, Denmark, 1993.
7. Masad E., Muhunthan B., Shashidhar N., and Harman T. Internal Structure Characterization of Asphalt Concrete Using Image Analysis. Journal of Computing in Civil Engineering, Vol. 13, No. 2, 1999, pp. 88–94.
8. Kose S., Guler M., Bahia H. U., and Masad E. Distribution of Strains Within Hot-Mix Asphalt Binders: Applying Imaging and Finite-Element Techniques. In Transportation Research Record: Journal of the Transportation Research Board, No. 1728, TRB, National Research Council, Washington, D.C., 2000, pp. 21–27.
9. Wegan V., Brule B., and Lefebvre J. The Structure of Polymer Modified Binders and Corresponding Asphalt Mixtures. Report 92. Danish Road Institute, Roskilde, Denmark, 1999.
10. Anderson D. A., Bahia H. U., and Dongre R. Rheological Properties of Mineral Filler–Asphalt Mastics and Its Importance to Pavement Performance. In Effects of Aggregates and Mineral Fillers on Asphalt Mixture Performance, ASTM STP 1147 (Meininger R. C., ed.), ASTM, Philadelphia, Pa., 1992.
11. Read J. M. New Method for Measuring Crack Propagation in Asphalts. International Journal of Pavement Engineering, Vol. I, No. 1, 2000, pp. 15–34.
12. Test Methods and Specification Criteria for Mineral Filler Used in HMA. NCHRP Project 9-45. Transportation Research Board of the National Academies, Washington, D.C., www.trb.org/TRBNet/ProjectDisplay.asp?ProjectID=979. Accessed Nov. 2007.
Cite article
Cite article
Cite article
OR
Download to reference manager
If you have citation software installed, you can download article citation data to the citation manager of your choice
Information, rights and permissions
Information
Published In
Article first published online: January 1, 2008
Issue published: January 2008
Authors
Metrics and citations
Metrics
Journals metrics
This article was published in Transportation Research Record: Journal of the Transportation Research Board.
VIEW ALL JOURNAL METRICSArticle usage*
Total views and downloads: 196
*Article usage tracking started in December 2016
Altmetric
See the impact this article is making through the number of times it’s been read, and the Altmetric Score.
Learn more about the Altmetric Scores
Articles citing this one
Receive email alerts when this article is cited
Web of Science: 0
Crossref: 66
- Impact of the mastic phase and compaction temperature on the sigmoidal...
- Microscopy-based approach for measuring asphalt film thickness and its...
- Experiment of static creep behavior of aggregate-asphalt interfaces
- Phase field approach to damage and fracture in asphalt concrete using ...
- Characterization of mortar film distribution of asphalt mixtures conta...
- Mesogenetic Evaluation and Design of Coarse Aggregate Contact within A...
- Investigation of average asphalt film thickness of dense graded asphal...
- Distribution of mortar film thickness and its relationship to mixture ...
- Factors Affecting Mortar Thickness Distribution and Its Relationship t...
- Estimating Asphalt Film Thickness in Asphalt Mixtures Using Microscopy...
- Stripping Potential of Asphalt Mixtures: State of the Art
- Analysis and assessment of respirable particles in asphalt pavement re...
- Determination of composite modulus of concrete containing reclaimed as...
- Assessing the Asphalt Binder Film Thickness in Recycled Asphalt Mixtur...
- Strain Sweep Fatigue Testing of Sand Asphalt Mortar to Investigate the...
- Study on the influence of aggregate strength and shape on the performa...
- Experimental Testing and Analysis Procedure to Determine the Apparent ...
- Effects of RAP residual asphalt binder type, content and ageing on the...
- Multiscale Modeling of Asphalt Concrete and Validation through Instrum...
- Analyzing the effect of waste jarosite as an alternative filler on the...
- Investigation of warm mix epoxy asphalt compaction with gyratory compa...
- Blending Between Aged and Virgin Asphalt Binders in Recycled Pavements...
- An experimental procedure to determine the surface area of fine aggreg...
- Effect of asphalt film thickness on shear mechanical properties of asp...
- Effect of binder film distribution on the fatigue characteristics of a...
- Forensic approach to predict film thickness of reacted and activated r...
- Asphalt-related emissions are a major missing nontraditional source of...
- Analysis of Composite Skeleton Characteristics of Recycled Asphalt Mix...
- Study on Binder Film Thickness Distribution of Recycled Asphalt Paveme...
- Investigation of sea salt erosion effect on the asphalt-aggregate inte...
- Fatigue characterization of binder with aging in two length scales: sa...
- A New Method for Designing Dense Skeleton Asphalt Mixture Based on Mes...
- New preparation method of bitumen samples for UV aging behavior invest...
- Prediction of dynamic shear modulus of fine aggregate matrix using dis...
- Use of reacted and activated rubber in ultra-thin hot mixture asphalt ...
- Identification and Characterization of Asphalt Concrete Phases Using N...
- Actual diffusivities and diffusion paths of water vapor in asphalt mix...
- Phase identification and characterization of aging effects in asphalti...
- Evaluation of Nanomechanical Properties of Nonaggregate Phase of Aspha...
- Asphalt binder adsorption by aggregates: a microscopic study
- Conceptualizing the asphalt film thickness to investigate the Superpav...
- Evaluating the mastic distribution of asphalt mixtures based on a new ...
- Effects of Diatomite–Limestone Powder Ratio on Mechanical and Anti-Def...
- Improvement of evaluation indicator of interfacial interaction between...
- Observation of asphalt binder microstructure with ESEM
- Effects of high friction aggregate and PG Plus binder on rutting resis...
- Measuring the binder film residues on black rock in mixtures with high...
- Multiscale imaging and characterization of the effect of mixing temper...
- Towards asphalt mixture morphology evaluation with the virtual specime...
- Optimization of Hot-Mix Asphalt Surface Course Mix Design for Fatigue ...
- Blending Measurements in Mixtures with Reclaimed Asphalt: Use of Scann...
- Laboratory Study to Evaluate the Influence of Reclaimed Asphalt Conten...
- New method to estimate the “re-activated” binder amount in recycled ho...
- Binder distribution model for asphalt mixtures based on packing of the...
- Heterogeneous Finite-Element Modeling of the Dynamic Complex Modulus T...
- Concept of Film Thickness Applied to a New Approach for Polymer Concre...
- Comparison Analysis of the Aggregate Contact Characteristics between S...
- The Research on Aggregate Microstructure Uniformity Image Processing o...
- Evaluating Fatigue-Cracking Resistance of Asphalt Binders in a Standar...
- Observation and evaluation of the degree of blending of reclaimed asph...
- Comprehensive Evaluation of Small Strain Viscoelastic Behavior of Asph...
- Characterization of HMA Mixtures Containing High Reclaimed Asphalt Pav...
- Three dimensional distribution of the mastic in asphalt composites
- Micro Scale Tensile Behaviour of Thin Bitumen Films
- Investigation of porous asphalt microstructure using optical and elect...
- Evaluation of moisture susceptibility of porous asphalt concrete using...
Figures and tables
Figures & Media
Tables
View Options
Get access
Access options
If you have access to journal content via a personal subscription, university, library, employer or society, select from the options below:
loading institutional access options
Alternatively, view purchase options below:
Purchase 24 hour online access to view and download content.
Access journal content via a DeepDyve subscription or find out more about this option.
